After a great deal of requests we have
designed a simple switch for all the Liteon drives that enables
firmware full read/write. We have also included an On/OFF Led to show
correction operation when switching to 0×72 vendor mode.
The installation is very simple and
takes about 60 seconds if you have some small experience with a
soldering iron. It has been tested with the original DOSFLASH methods
and also the new Jungle Flasher 0.1.69. All Liteon drive version have
been tested with 100% Success. There is no need to remove the LT Switch
after it has been installed ? simply switch to normal mode.
Redesigned circuit to give a cleaner filter when switching to Vendor
mode. No more read errors !
Enlarged solder points to give an easier flow to the Liteon PCB
points ? Noob friendly !
Added Read/Write Mode LED (RED)
Added Normal 360 Mode LED (Green)
Upgrade the switch to a stronger more robust model
Changed location of LED so they can be viewed when Liteon PCB is
installed to its case
Slight improvement to the PCB shape so it sits firmly and accurately
in place when soldering.