Arcade VGA -> HDMI Video Converter SG-VC9900
SG-VC9900 - Professional HDMI adapter for arcade / arcade cabinet.
Ideal for those who want to replace a tired CRT screen with a modern HDMI flat screen on eg. an arcade cabinet or the bowling alley monitors.
24-bit video chip with excellent video quality.
Good color reproduction without interference or shadows.
Automatic support for 15KHz, 24KHz and 31KHz video signal
OSD On Screen Display menu for settings (English, Chinese)
Analog potentiometer to adjust for RGB input signal.
Converts RGBS, RGBHV. CGA, EGA and VGA to HDMI (640x480, 800x600, 1024x768, 1360x768)
Settings to move / zoom the image to fit the screen perfectly.
Power supplied with DC 5V 2A (+/- 0.5V)
- CGA / EGA 14.5-16.5K 23.5-25.5K 30.5-32.5K Auto scan
- RGBHV 30.5-32.5K Auto Scan
- VGA 30.5-32.5K Auto scan
- HDMI 640 * 480,800 * 600.1024 * 768.1360 * 768
- Input Switch
- Image Zoom
- Image Position
- Output Resolution
- R \ G \ B gain adjust
- Menu Key
- R \ G \ B VR
- 115 * 99 * 1.6mm
- - “MENU” open OSD menu, and enter
- - “UP” up and increase
- - “DOWN / AUTO” down and reduce
- Press this key auto scan CGA / EGA signal
- Press this key over 5 seconds and release reset system ** (this operation is invalid when you open OSD menu)
- “SW” switch input signal / RGBS / RGBHV ** (this operation is invalid when you open OSD menu)
- "Clamp sp" & "Clamp" please do not adjust this button except the monitor have black item.
- More functions control please look to OSD to operation.
Frequently Asked Questions and Answers / FAQ
- No signal on you monitor
-please check input and output cable, make sure all cable it's connected. And make sure it's on. Display on you monitor it's “No signal” please press “SW” to switch input signal.
- Input not supported
-when you monitor display "input not supports" maybe you need change to low resolution.
Please press “DOWN / AUTO” over 5 seconds and release. system reset two 800 * 600 output.
- Image not full on you screen
-please enter menu adjust image position and zoom.
- Image shake or freeze
-please press “DOWN / AUTO”, system auto scan input signal and restore image.
- Have black item on screen, or all screen it's too black.
-please adjust "Clamp sp" and "Clamp st", please keep "Clamp st" less than "Clamp sp".
- Image color not right
-please adjust R \ G \ B VR.
|Denna produkt har utgått ur sortimentet||No|